and another thing, canbus connection?
Posted: Tue Aug 16, 2016 4:18 pm
I'm going to be using the canbus to feed engine info to the the mshift. The only canbus thing I saw on the board was termination resistor. I found something somewhere that said canbus would be on pins 13 and 16 of the 35 pin connector. I put those wires in the connector but I'm wondering what they connect to on the board? I don't recall building any circuit for canbus? Is it magic or did I miss something? I looked again at the list of connections in the Jumper chart, don't see anything about it.