I am building the GPIO board for a 4L80e 2005 transmission.
On step I5 in the instructions, you say to install r59 and r62. Should the r62 be r61 instead? Since there are no other parts installed in the VR4 area.
My next question, is there a cross reference for the AMP seal pin (wires) to the Transtim for testing?
4L80e Build and testing with the Transtim
Re: 4L80e Build and testing with the Transtim
Adrian
yes the resistror goes in R61 and there is no crossfrerance for the sim just fallow the the wiring diagram
Dave
yes the resistror goes in R61 and there is no crossfrerance for the sim just fallow the the wiring diagram
Dave
49 Willys panel wagon, 383stroker, Hilborn EFI conversion,msII v3, EDIS ,4L80E 