MSgpio.com read only forums (Jan.15,2018)

I want to use a 68rfe transmission behind a Cummins 4BT installed in a Dodge Dakota. Is there anyone out there with experience using a GPIO board on this transmission? It would be a stand alone GPIO application as this engine has no electronics on it. To date, I have not located any technical in on this transmission. If someone can help, it would be most appreciated.

I think the 68RFE is very similar to the 5-45RFE, they share the same design. So it should be possible to control it with MShift.
I've been working on the 5-45RFE but dont have time at to moment to complete the setup.