MSgpio.com read only forums (Jan.15,2018)

Hi there,

New to this type of controller.

But let's get right to it.

I have a BMW E46 SMG transmission "this is a electro-hydraulically controlled manual transmission"

Basically there is a solenoid for the clutch PWM "with position sensor 0-5v"
Haven't quite mapped out the gear mechanism yet, but there is two position sensors and 5 other solenoids here.

Is there any hope of programming the MegaShift for this transmission? "the transmission at hand is the GS5S31BZ "


Any help is appreciated!

Is there any hope of programming the MegaShift for this transmission?

Snake,

It's hard to say without knowing a *lot* more about the transmission.

Here are the usual details regarding SMG control