MSgpio.com read only forums (Jan.15,2018)

I connect my Megashift (CAN1) to Tunerstudio via my MS2 ECU.. however, when I calibrate the thermister values for megashift (CAN1) in Tunerstudio it applies the changes to the main MS2 ECU project even though I select CAN1

Do I need to connect the Megashift to Tunerstudio independently to calibrate its thermister?

Addicted,

I think so. In theory you shouldn't have to, but something in either TS or the INI isn't quite right obviously (though I don't see anything amiss in the INI at first glance).

Lance.

I am actually having this same problem with my calibrations. I just connect independently to the TCM with the serial cable and all is well (inconvenient when you want to perfect a measurement while viewing real time temps, though).

Sam

I ran into this problem a few months ago and posted a thread on it here. I also contacted James and Phil about it and they said MS3 does support CAN based calibration, however it was a method that Phil and James developed and is not supported with Megashift apparently, so you have to connect directly to GPIO through serial connection to calibrate.


Andrew

certainly do..cos otherwise like me you will find you have just recalibrated your ms2 engine coolent sensor..bugger