Page 1 of 2
GPIO being made up at CM right now...
Posted: Fri May 02, 2008 9:59 am
by BowlingSuperior
As of right now (May 2, noon EST) 100 GPIO boards are making their way down the contract assembly line for SMT assembly! I should have these in-hand by the end of next week, I will then blast in a bootloader and check them out. t which point the first boards will be available
- Bruce
Re: GPIO being made up at CM right now...
Posted: Fri May 02, 2008 11:52 am
by dch
woo hoo
that is great news Thanks
Re: GPIO being made up at CM right now...
Posted: Fri May 02, 2008 8:13 pm
by rufusbooth
Sweet! I will finally be able to get my truck on the ROAD! Thanks for the great update! This is excellent news! Consider this the first order, where do I send my Greenbacks?
Cheers,
Rufus
Re: GPIO being made up at CM right now...
Posted: Sat May 03, 2008 10:40 am
by Brad-Man
Yes - GREAT NEWS! - how to go about getting one - is anyone going to supply built ones and/or kits?
Re: GPIO being made up at CM right now...
Posted: Sun May 18, 2008 3:55 pm
by Blk 02
so excited.... are these ready now? Can't wait much longer
Graham
Re: GPIO being made up at CM right now...
Posted: Wed May 28, 2008 11:08 am
by Bernard Fife
Graham,
These are not ready quite yet. Bruce has to burn the bootloader on them (my P&E BDM cable is dead, and I haven't replaced it yet). Then the boards need to come to me (mail or courier) for the final check-over (I have to build one and confirm all is well) and verifying the BOM, assembly instructions, etc.
Bruce may have already sent the production boards, I haven't asked him in the last week or so. When they get here and I have things in place, I will post a follow-up.
Lance.
Re: GPIO being made up at CM right now...
Posted: Wed May 28, 2008 11:47 am
by rufusbooth
Thanks for the update Lance! They keep me motivated to get my truck ready for the GPIO when it is ready.
Cheers,
Rufus
Re: GPIO being made up at CM right now...
Posted: Wed Jun 04, 2008 5:30 am
by BB69
I am also excited about seeing these boards. I am currently wiring up my engine and getting ready to fire it the first time. I will start with a stock ECM until the GPIO board is available. Then I will switch over to MS to run the engine and trans.
Thanks for the updates.
Ken
Re: GPIO being made up at CM right now...
Posted: Mon Jun 09, 2008 12:03 pm
by h22
Sweet
been a long wait, but it will be worth it, put me down for one, now i need to order a trans kit and start rebuilding my 4l60e! will they be available throught the standard supliers?
Joe
Re: GPIO being made up at CM right now...
Posted: Mon Jun 09, 2008 1:20 pm
by Brad-Man
My 4L60E has already been rebuilt.
I am awaiting the GPIO board before ordering my MS2 and torque converter.
I have had a part in developing an adapter kit for GM trannies to Datsun L series engines, and can't wait to put the 4L60E behind mine and not have to deal with Atlanta traffic and a 5 speed tranny anymore!