MSgpio.com read only forums (Jan.15,2018)

Posted: **Mon Aug 29, 2016 4:46 pm**

went into tranny dash today and found no temp sensor. went to calibrate with default gm settings and got error
"calibration table write failed!" response packet failed validation: controller reported a out of range.
3 point therm generator gm sensor values bias resistor value 2490.0
-40 100700.0
86 2238
210 177

joestrans_CurrentTune.msq: (62.05 KiB) Downloaded 720 times

Monitor_5201.abs.s19: (88.8 KiB) Downloaded 521 times

Posted: **Tue Aug 30, 2016 4:56 pm**

was able to reload configuration..... was trying thru canbus like I have been able to do many times

but tried with direct serial connection and it took

MSgpio.com read only forums (Jan.15,2018)

gm sensor calibration

gm sensor calibration

Re: gm sensor calibration