Put Trans in Neutral won't shift till stop

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
shaodome
Posts: 58
Joined: Thu Aug 22, 2013 6:28 am

Re: Put Trans in Neutral won't shift till stop

Post by shaodome »

Glad to know I'm not crazy :mrgreen:

I'll update to the latest stable release (prior to going back to the 5.x beta codes) and see if I can get the weird target behavior to come back.
thatswagenwagen
Posts: 25
Joined: Tue Aug 26, 2014 12:49 pm

Re: Put Trans in Neutral won't shift till stop

Post by thatswagenwagen »

Seeing as MegaShift is only for track use, I see no safety hazard unless you are illegally driving your car on public roads :mrgreen:
zen
Posts: 49
Joined: Mon Jun 02, 2014 1:38 pm

Re: Put Trans in Neutral won't shift till stop

Post by zen »

it would be real nice if it did not do this..whst is legal and what is done are not usually the same..
Ap67et10
Posts: 42
Joined: Tue May 13, 2014 12:06 am

Re: Put Trans in Neutral won't shift till stop

Post by Ap67et10 »

yeah because having to come to a stop to get the trans to engage in the middle of the race track is so much better.....
Post Reply