5V ---> 6.3V

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
tmoble
Posts: 55
Joined: Fri Nov 25, 2011 1:01 pm
Location: Glendale, Az

Re: 5V ---> 6.3V

Post by tmoble »

maybe I'll just go somewhere and shoot myself. Anybody reading carefully at all might have noticed I stated I was having trouble with the transistors I installed JP1, 2 , 3 and 4. Unfortunately, those transistors go in spots labelled Q9, 10, 11 and 12. Of course, all you heavily experienced guys noticed that and were just waiting to see how it would take me to notice, right? :)

Maybe now after I get more of the transistors installed the gear indicator LEDS on the stim will work.
tmoble
Posts: 55
Joined: Fri Nov 25, 2011 1:01 pm
Location: Glendale, Az

Re: 5V ---> 6.3V

Post by tmoble »

I think I'll ask my wife's prayer group to take up for the SMT processor on that board. Or cast the bones or something.
Post Reply