gm sensor calibration

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Rukavina
Posts: 47
Joined: Fri Aug 15, 2014 7:58 pm

gm sensor calibration

Post by Rukavina »

went into tranny dash today and found no temp sensor. went to calibrate with default gm settings and got error
"calibration table write failed!" response packet failed validation: controller reported a out of range.
3 point therm generator gm sensor values bias resistor value 2490.0
-40 100700.0
86 2238
210 177
joestrans_CurrentTune.msq
(62.05 KiB) Downloaded 708 times
Monitor_5201.abs.s19
(88.8 KiB) Downloaded 511 times
Rukavina
Posts: 47
Joined: Fri Aug 15, 2014 7:58 pm

Re: gm sensor calibration

Post by Rukavina »

was able to reload configuration..... was trying thru canbus like I have been able to do many times ;) but tried with direct serial connection and it took
Post Reply