MSgpio.com read only forums (Jan.15,2018)

so..did my best to copy oe (bmw in this case can bus wiring) so what i did was get 2 lenghts of nice fire proof (as is now standard, ie not pvc covered) lowish current cable( i recon 8amp continuous), used this as its nice and strong, got Mrs to hold far end of cables together and put my end in a el...

let me explain.this is the first auto i have owned,i dont like them, but am trying too!! (as i see its potential).SO NOT SURE if this is normal, or NOT.?? so before can bus issue..(see other post..sigh) gearbox will freewheel if i let off throttle and its like its in neutral untill i allow engine sp...

today...ruby (the 1971 range rover ) decided it would be good to lose all can bus ..great..no gearbox control in peak rush hour with a massive crash 10 miles ahead with 1 mph traffic..just what i needed..NOT so got her home by using just 3rd (default for gearbox with no control in low range....) hav...

hi lance..

link dont work...but am assuming its 4.146..if so downloaded and will try tomorrow..
regards

it appears i wont ..due to can bus failure!! sigh....

firmware 4139 firmware.with ms2.. tcc locks/unlocks every second or less at around tcc min lock speed...ie oscillates..BUT TCC time hysterisis is at 7.5sces and load 5.. abit confused..and its not nice to drive, have to drive though it to allow it to be stable..proberly me doing something wrong,BUT ...

it would be real nice if it did not do this..whst is legal and what is done are not usually the same..

certainly do..cos otherwise like me you will find you have just recalibrated your ms2 engine coolent sensor..bugger

Hi Lance well i scoped the VSS input to the lm2907 conditioner crt..all was well. nice sine wave in (no real noise, but more than enough to take out the gpio without the lm2907)..BUT output from lm2907 voltage droped from 5v square wave to 1v at 60 mph..TEST done with transfer box in neutral, runnin...

Hi Lance Yes i have over revving enabled,i will lower it! I have a scooe yes,but quite tricky to check ,i will remove both props and try it like that And post up pics of scope display Will set madking to 0 and try it on way home. At the moment this is my daily drive as i destroyed the clutch on the ...

update..(this is before vss issue)

rewired canbus and turned off gear lever errors as you suggested..seems ok now thanks..

SO anyone reading this in the future..re do your can bus wiring..its been perfect since..