MSgpio.com read only forums (Jan.15,2018)

somethings not 100% i went for a drive today, had no gears (ie only 1st) initially. I stopped and cycled the ign and then had all 4 gears until i came to a stop about 2km away then it was stuck in 1st again. unfortunately i didnt have my laptop with me so had to disconnect the gpio and reconnect my ...

lance, it still shifts gears, but TS reports shifter position and current gear correctly - its just all the other gauges ie rpm, load, temp etc that go crazy so this means comms (serial) are ok. laptop serial is fine on other controllers it could be can interference, but if it was then it wouldnt sh...

Played around with the latest release code today and saw gauges in tunerstudio go crazy, log is attached, this is direct to the serail port of the gpio, and engine data over can

Lance, In regards to Ford - voltage based shifter, there seems to be a bug in the code in relation to ADC and manual gear, this seems present on both v2 and v4 code bases and i have replicated it both in the car and on the bench. Basically using the default thresholds (as they are correct for my veh...

i seem to have an issue with both 2110 and 4007 - on 2110, i load the firmware from scratch, open tunerstudio, load the project etc, make only one change, that is configure shift lever type to 'voltages (ford)' and click burn, flash/burn lights up but will not complete the burning process. if i powe...