MSgpio.com read only forums (Jan.15,2018)

ah ok! , its not entirely strait forward i had to do some looking around and playing to figure it out! .

as for the analog input for the shifter, my shifter is prnd only and the controler doesn't need to know when its doing other than drive.

set up like this it will do everything I ever wanted :D ...

How would i enable the the 6 solonoids ? ( out puts 4-5 -6 are grey ed out )
i was looking though i could use the led outputs with realys or drivers to do this.
but i would like to use the medium current on off drivers to do this as they are meant for that.

i was also thinking of using the tcc ...

Hi Lance,

I have not installed the megashift yet, too busy.

but i recently thought of some thing and wanted your input on it.

most new auto trannys use the tcc in acceleration, it splits up the gears and makes it slightly more economical.
from what i understand the tcc control is only used in ...

the shifter position input only needs 1 to indicate drive.. any other position doesn't matter. its only so the megashift doesn't try shifting through the gears when your backing up. not that it would even matter because the hydraulic functions of the soloniods are not even getting fluid. the mega ...

geese i got way behind in this stuff !

where to start .. humm .. well for the shifter position input i was planning on using 1 wire to indicate "D" this it thats all .. when the manual shifter is any where els the megashift does not need to know. in any location i hope the ms shift will continue ...

Frank,

After a quick look, I don't believe you need to change the code. There are 3 shift solenoids, and 2 spare outputs that can be set by gear and other parameters ( http://www.msgpio.com/manuals/mshift/V2tune.html#s ). So there's your 5 outputs.

There is already PWM line pressure control via a ...

gurov,

Engine braking for the 4L60E is only if the selector is in 1, 2 or 3. I can't recall off the top of my head if D is 4th (=overdrive) or 3rd (with OD marked for 4th - I believe my van had a D with a circle around it for 4th, and a plain D for 3rd). So I always use the gear number, rather ...

ok have 2005 subaru legacy gt. i jsut swaped in a 1987 buick 3.8 and holset turbo.
i have the gpio board and i'm in the process of setting it up for the 5 speed tranny.

the shifter is tiptrionic type where it has drive and then slid over for sports mode and then can be manually shifted.
so one ...