MSgpio.com read only forums (Jan.15,2018)

Sweet thanks again.

May be a dumb question, as I dont know 4L60E or electronic trans control well and I dont have the trans in front of me yet.
Was planning to adapt an oldschool hurst shifter I have to do the movement, there are def no wires or position sensors on it, can I assume these sensors generally on/in the ...

Now im building the GPIO board to control a 4l60E and ran into another question.... should I make a new topic?

Question is, in step E of the build instructions it state if using a GM shifter... probably gonna make my own shifter setup for the project truck it will have Park, Reverse, Drive then a ...

Upon further inspection it was that all the tabs on the bottom were slightly off and with a bit of bending them I got it to press onto the board and soldered up

So got my digikey order today so I could build my stim board and it appears that the EG1953-ND rotary switch isnt the right one for the board. Anyone have a recommendation on which one I need to order?
Thanks

Heyhey, new to the MS scene and putting together my first order and had a question.
I have the Ms3pro manual and have gone through most of the gpio 4l60e stuff. But i wanted to confirm that the GPIO canbus will work with the ms3pro module, as the ms3pro manual says microsquirt trans control via ...