MSgpio.com read only forums (Jan.15,2018)

Fair enough. Just offering as I already have a working setup thats wired without any issues.

Thanks,

Joe

If you are looking for beta testers I'M running a microsquirt controlled 4l80E at the moment.
Been working good for several years now. I could be testing with just a minor repin of the amp connector.

Keep me posted if I can help.

Joe

I like Lance's approch.

Seperate out the high dollar chips and include the rest as base kit.

Like the V3 board. I always have several extra's. Just part of buying the kit.

I still like the idea of all the resistors and caps etc.. included in the base kit.
Maybe enough to build the base kit with ...

I would like the Ala Carte method the best but realize this would be a pain in the rear.

Example. Base board with 4 egt's 2 adc's and 2 high current.

I think maybe groups of features might be a good method.

None of the components are teribly expensive so to have a few extras shouldn't be a big ...

Lance,

Thanks for the reply- Thats what I was looking for.

Joe

Looking through the GPIO docs I see a reference to a digikey MSP6907-ND sensor used for line pressure measurement.

Reviewing the Digikey datasheet I am unable to find any kind of pressure/voltage reference.

Anybody have any information on this sensor voltage/pressure?? Will there be an MSP6907-ND ...

Lance , Bruce,

Thanks for the reply. Just haven't seen any comment on price yet so I thought I would ask.

Ball park is great. Trying to plan a little and just wasn't sure if I was looking at $100 or $500.

$160 is great give or take $50 - $100

Looking forward to the release.

Joe

Any word yet??

Just curious mainly. Getting ready to put a 4L80E in my truck. Still have lots to do.

Thanks,

Joe

Lance,

Now that things are in the final stages any Idea what basic cost would be??

Basic populated GPIO board. (Board and SMD only)

Fully populated board with all circuits??

Thanks,

Joe-

Lance,

The 4WD low circuit seems very consistent over the years and models I had a chance to check.

The push button 4WD uses the TCCM to pull the PCM signal low for 4WD low shift points.
The manual shift 4WD low just has a switch on the T-case that pulls the circuit low.

I checked multiple ...