MSgpio.com read only forums (Jan.15,2018)

Hi Tim

There is a picture on page 2 of this thread that shows the location, the resister is put in the wiring harness.
I would put the picture here but have not figured out how yet.

brad

Hi dch,

Hi all the input speed sensor being used as a tach might will not work, as the rpm will change when the tranny is in 4th gear!
Unless the code is changed to know that.

Brad

Hi again Tim

You can a TPS ,MAP or MAF to the megashift for standalone, the 4L60E build guide tells how to add th parts. If megashift is connected to CAN, megashift gets
info for load,rpm plus someothers. With CAN not connected you lose the over/under rev protection and battery votage PWM ...

Hi Tim

I can answer some of your questions. the input speed sensor is not used for engine rpm. VR3 is for the input sensor and the VR1 is used for the output speed sensor. the PCM switchs are circuits, switchA is EGT4 ,switchB is GP12, and switchC is EGT3. As for the 2wd/4wd switch, if you have ...

Lance,

The range of transfer case low ranges are 1.96,2,2.61,2.72 the most popular for manual or electronic shift, new venture case.
2.48,2.74, 2.69 for the borg-warner case. and for the import 1.96,1.99,2.28,2.31,2.57. the aftermarket t-case can go as high as
6.00:1 that i have seen. there are ...